elevator car

英 [ˈelɪveɪtə(r) kɑː(r)]

美 [ˈelɪveɪtər kɑːr]

网络  电梯轿厢; 轿厢; 电梯车厢

英英释义

noun

• where passengers ride up and down
  1. the car was on the top floor
  Synonym:car

双语例句

• This paper establishes the model of the transmission system of the PQS-3-D Elevator for Car with the traditional approach of modeling and analyzes the model in vertical direction to meet the needs of market and design.
  本论文就是在这种形势下，响应市场的需求和设计的需要，对PQS-3-D型汽车专用升降机的机械传动系统，采用动力学理论建模方法，进行垂直方向上的建模及分析。
• For optimization efficiency of the elevator, the elevator car occupancy percentage is an important data. Existing weight measure system can only measure the weight in the elevator car and can not identify the occupancy percentage.
  对于电梯效率最优化而言，轿厢空间被占用面积是一个关键数据，但现有的电梯称重装置只能检测出轿厢中的重量，无法识别轿厢空间占用率。
• The light turns on as soon as the elevator car is activated, such as when the elevator doors open.
  电梯启动像电梯开门这种情况下，灯会立即开启。
• Vibration acceleration response of the elevator car is used as feedback signal and thus the engineering implementation of the active control will be simplified.
  采用电梯矫厢的振动加速度作为反馈信号，将使主动控制在工程上易于实现。
• ⑵ Through MATLAB software on traction elevators were 12 degrees of freedom vibration model and the horizontal direction perpendicular to 8 degrees of freedom vibration model simulation, respectively, high-speed elevator car by the maximum peak to peak vertical vibration and horizontal vibration of the dynamic model curve.
  ⑵利用MATLAB软件分别对曳引电梯的12自由度垂直振动模型和水平方向8自由度振动模型进行仿真，分别得到高速电梯轿厢垂直振动的最大峰峰值与水平振动的动力学模型曲线。
• The vibration equations of elevator car and guide rail was established, and the relations of variables such as displacement, velocity and excitation force between guide rollers and rails were given by satisfying the geometry compatibility and force equilibrium condition.
  分别建立轿厢与导轨振动分析数学模型，基于两者几何相容性与作用力平衡条件，给出导轨与导轮位移、速度、激振力耦合关系。
• Design of an elevator car controller based on CAN Bus
  基于CAN总线的电梯轿厢控制器设计
• Using numerical methods, adopt matlab programming, and obtain the elevator car vibration displacement, velocity and acceleration of the dynamic response simulation curve.
  运用数值计算方法，采用matlab仿真，得出电梯轿厢振动位移、速度、加速度的仿真曲线。
• The influence on traction capability caused by the change of elevator car's weight is analyzed in the terms of lift traction condition, for elevator rebuilding is always related to the car rebuilding.
  在电梯改造过程中常涉及到对轿厢的改造。从电梯曳引条件的角度，分析了常见电梯轿厢重量改变对曳引能力的影响情况。
• Finite Element Analysis on A Hydraulic Elevator Car Frame
  液压电梯轿厢架的有限元计算